Blown-In Insulation in Lewisville, TX

Blown-in insulation is the most efficient way to add R-value to an existing attic. Loose-fill fiberglass or cellulose is blown into the attic floor to the correct depth, covering the joists and any existing insulation evenly. It's faster than batt installation, performs well in Denton County's climate, and is typically the right choice for attic upgrades in existing homes.

Lewisville sits in Denton County along the shore of Lewisville Lake, and its housing stock spans a wider range of construction eras than many of its newer DFW neighbors — an older, more established core built through the mid-to-late 20th century, alongside substantial newer development along the Highway 121 and I-35E corridors as North Texas growth pushed outward from Dallas. Older Lewisville homes, particularly in neighborhoods closer to Old Town, commonly carry attic insulation typical of 1960s-80s construction — a meaningful step below current recommendations for North Texas's climate. Denton County sits on Blackland Prairie clay similar to the rest of central DFW, and shares the Metroplex's seasonal pattern of hot, humid summers followed by sharp winter cold fronts. Lewisville's mix of an older lake-town core and newer corridor development gives it a genuinely layered insulation profile — closer in character to established cities like Carrollton and Irving than to newer, more uniformly recent-construction suburbs like Murphy or Kyle.

Fiberglass vs. Cellulose Blown-In

Blown-in fiberglass is white, light, and maintains its R-value even when it gets slightly damp. Blown-in cellulose (made from recycled paper) is denser, settles more over time, and has slightly better resistance to air movement through the insulation layer. Both are good options — we can advise on the better choice for your specific attic conditions and R-value goals. Neither material is universally the better choice — the right pick usually comes down to a handful of practical factors specific to your attic rather than a general rule.

• Existing insulation type — blowing cellulose on top of old fiberglass (or the reverse) is generally fine, but a contractor will check compatibility and settling behavior before recommending a mix.
• Fire and pest resistance — cellulose is treated with borate for fire and pest resistance as part of manufacturing; fiberglass is naturally non-combustible without needing chemical treatment.
• Attic ventilation — in a well-ventilated attic, both materials perform close to their rated values. In a marginally ventilated attic, fiberglass's better tolerance of incidental moisture can be an advantage.
• Density and coverage — cellulose's higher density means it can be slightly more resistant to wind-washing near soffit vents, a detail that matters more in attics with significant airflow near the eaves.

How Much to Add and Where

Your contractor measures your existing insulation depth and calculates your current R-value, then tells you exactly how much additional insulation is needed to reach the recommended level for Denton County. Depth markers are installed in the attic so you (or a future inspector) can verify the installed depth. The job is clean and typically completed in a few hours for a standard attic. Even coverage matters as much as total depth — a blower hose passed too quickly over an area leaves it thinner than the rest of the attic, which is why depth-marker verification at multiple points, not just near the hatch, is part of a proper job rather than an optional extra.

• Pre-installation prep — air sealing bypasses and installing baffles at soffit vents (to keep insulation from blocking attic airflow) happens before material goes in.
• Even distribution — the installer works the attic systematically rather than just filling from one access point outward, which is where uneven coverage most often comes from.
• Settling allowance — cellulose in particular is blown to a slightly greater initial depth than the target R-value requires, accounting for expected settling over the following months.
• Depth verification — markers placed at multiple points let you (or a future home inspector) confirm the installed depth without needing to measure by hand.

This content is reviewed by the Texas Insulation Pros editorial team and informed by licensed-contractor sourcing, manufacturer documentation, and established industry standards for Insulation. Read our editorial standards.