Blown-In Insulation in Carrollton, TX

Blown-in insulation is the most efficient way to add R-value to an existing attic. Loose-fill fiberglass or cellulose is blown into the attic floor to the correct depth, covering the joists and any existing insulation evenly. It's faster than batt installation, performs well in Dallas County's climate, and is typically the right choice for attic upgrades in existing homes.

Carrollton sits across both Dallas and Denton counties in the DFW Metroplex, an older, more established suburb than the newer cities pushing the Metroplex's northern edge. Much of its housing stock dates from the 1970s-80s suburban expansion that followed the growth of nearby corporate campuses, built to the energy codes of that era — typically several inches short of current attic insulation recommendations for North Texas's climate zone. The city sits on Blackland Prairie clay, the same expansive soil common across central DFW, which affects slab performance more than attic insulation directly but is a relevant factor when foundation movement opens gaps around penetrations that insulation and air sealing both need to address together. Carrollton's older, tree-shaded neighborhoods trap humidity similarly to nearby Farmers Branch and Addison, and the summer-to-winter cycling typical of North Texas — hot, humid summers followed by sharp cold fronts — puts steady thermal stress on the thinner insulation still common in the city's 1970s-80s housing stock.

Fiberglass vs. Cellulose Blown-In

Blown-in fiberglass is white, light, and maintains its R-value even when it gets slightly damp. Blown-in cellulose (made from recycled paper) is denser, settles more over time, and has slightly better resistance to air movement through the insulation layer. Both are good options — we can advise on the better choice for your specific attic conditions and R-value goals. Neither material is universally the better choice — the right pick usually comes down to a handful of practical factors specific to your attic rather than a general rule.

• Existing insulation type — blowing cellulose on top of old fiberglass (or the reverse) is generally fine, but a contractor will check compatibility and settling behavior before recommending a mix.
• Fire and pest resistance — cellulose is treated with borate for fire and pest resistance as part of manufacturing; fiberglass is naturally non-combustible without needing chemical treatment.
• Attic ventilation — in a well-ventilated attic, both materials perform close to their rated values. In a marginally ventilated attic, fiberglass's better tolerance of incidental moisture can be an advantage.
• Density and coverage — cellulose's higher density means it can be slightly more resistant to wind-washing near soffit vents, a detail that matters more in attics with significant airflow near the eaves.

How Much to Add and Where

Your contractor measures your existing insulation depth and calculates your current R-value, then tells you exactly how much additional insulation is needed to reach the recommended level for Dallas County. Depth markers are installed in the attic so you (or a future inspector) can verify the installed depth. The job is clean and typically completed in a few hours for a standard attic. Even coverage matters as much as total depth — a blower hose passed too quickly over an area leaves it thinner than the rest of the attic, which is why depth-marker verification at multiple points, not just near the hatch, is part of a proper job rather than an optional extra.

• Pre-installation prep — air sealing bypasses and installing baffles at soffit vents (to keep insulation from blocking attic airflow) happens before material goes in.
• Even distribution — the installer works the attic systematically rather than just filling from one access point outward, which is where uneven coverage most often comes from.
• Settling allowance — cellulose in particular is blown to a slightly greater initial depth than the target R-value requires, accounting for expected settling over the following months.
• Depth verification — markers placed at multiple points let you (or a future home inspector) confirm the installed depth without needing to measure by hand.

This content is reviewed by the Texas Insulation Pros editorial team and informed by licensed-contractor sourcing, manufacturer documentation, and established industry standards for Insulation. Read our editorial standards.